Dinan Stage 3 Performance Engine Software - 2011-2012 BMW Alpina B7

F01/F02

PART# D903-44TB73

Be the first to write a review

Overview

Stage 3 Engine Software is for use with the High Flow Intake/Strut Brace, ensuring optimum performance and drivability. The Dinan Performance Engine Software safely increases turbo-boost pressure from the stock 14.0 to 18.0 psi, along with properly retuned fuel mixtures, ignition timing, and full map rescaling. In fact, over 2000 lines of code have been addressed, producing substantial increases in power output while maintaining the civility and reliability expected of a Dinan performance product. The top speed governor is removed with Dinan's software, the B7 will be capable of achieving its natural top speed as the governor has been removed.

Features:

  • More Power (with exhaust and intake/strut brace): Max gains of +96 HP @ 6500 RPM and +144 lb-ft TRQ @ 6500 RPM
  • Improved throttle response
  • Top speed governor removed
  • Full Map Rescaling, for drivability from idle to wide open throttle and everywhere in between
  • Properly Returned Fuel Mixtures, to save you gas and protect your engine
  • Retain all BMW factory engine damage safeguards

Specs

BrandDinan
Dinan Point Value3
Emission Code4
Factory Rated HP500
Factory Rated Torque (lb-ft)516
Labor Time (Hours)0.5
Max HP Gain96 @ 6500 RPM
Max Torque (lb-ft) Gain144 @ 6500 RPM
Peak HP587 @ 5500 RPM
Peak HP Gain87 @ 5500 RPM
Peak Torque (lb-ft)650 @ 3500 RPM
Peak Torque (lb-ft) Gain134 @ 3500 RPM
Product TypeEngine Software
Required ItemsDinan Cold Air Intake / Strut Brace (D760-0033)
Weight1
Part NumberD903-44TB73

Emissions

4

This part is legal for sale or use on Racing Use Only Vehicles

The following vehicles are considered Racing Use Only Vehicles:

  • Racing Use Only Vehicles are vehicles that are used exclusively for competition that are not registered and that may never be used on the street

WARNING: It is against the law to install this part on an Emissions Controlled Vehicle

Tech Resources

Not compatible with Alpina B7's (F01/F02) from 2013+. When programmed the pressure sensors in both intercoolers must be replaced with 2x BMW 13 62 7 585 494. Refer to TIS procedures 1362591 and 1362592. These sensors are not included with the software and must be purchased separately from your BMW dealer Dinan High Flow Intake/Strut Brace is required in order to run the Stage 3 Performance Engine Software.

Applications

Reviews

    *Free Shipping & Handling only offered to the contiguous US on orders over $100, excludes clearance parts and oversized packages.

    Some parts are not legal for use in California or other states with similar regulations.